Guest Join UsHey Guest,
Welcome, Join our awesome community where you can discuss on various topics :-
Some point about your community
Some point about your community
Some point about your community
Some point about your community
Some point about your community
Some point about your community
Some point about your community
Much More.. or Create an Account


{myadvertisements[zone_1]}
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Failure Analysis of Industrial Furnace
#1
Each reversing valve is equipped with a pneumatic triple, which should be regularly refueled, slag cleaned, and drained. When refueling, first close the front hand valve of the pneumatic triple piece, and then remove the oil cup to add oil. The oil volume of the oil cup should not exceed the full scale. The oil is the atomized oil specified by the pneumatic triplet, and can also be replaced by 32# turbine hydraulic oil. Surgical instruments stainless steel vacuum heat treatment The atomization speed of the oil should be adjusted to 3 to 5 days to atomize a cup of oil. When refueling, if necessary, slag removal and drainage can be carried out together. If the pneumatic triplet does not atomize oil, the triplet should be repaired or replaced in time.Die Steel & Vacuum Heat Treatment News When the reversing system fails and alarms, find out the fault point according to the alarm indicator displayed on the control cabinet, and carry out timely treatment after on-site inspection and confirmation to restore the normal operation of the reversing valve. If the air pipe bursts or falls off, close the compressed air supply valve of the reversing valve and replace the corresponding air pipe immediately. If the limit switch is loose and cannot contact the circular iron sheet on the valve stem, the rotation angle of the limit switch can be adjusted immediately to ensure the normal contact between the reversing valve plate and the limit switch contact wheel when it is at the front and rear limit positions. If it does not belong to the above 1), 2) cause the alarm, check whether the solenoid valve operates normally, and replace the solenoid valve if necessary. Vacuum Heat Treatment For Parts ProductionIf it does not belong to the above 1), 2), 3) fault alarm, check whether the cylinder is leaking, and whether the wiring of the limit switch and the solenoid valve is normal.Vacuum Heat Treatment Of Aluminum Alloys News
Reply
{myadvertisements[zone_3]}


Possibly Related Threads...
Thread Author Replies Views Last Post
  What is the control design of the electric furnace? wyd1014 0 254 08-02-2022, 04:30 AM
Last Post: wyd1014
  What does the aging furnace do? wyd1014 0 242 07-29-2022, 09:23 AM
Last Post: wyd1014
  Introduction of induction furnace wyd1014 0 252 07-27-2022, 05:37 AM
Last Post: wyd1014
  Equipment use of industrial furnaces wyd1014 0 244 07-26-2022, 05:44 AM
Last Post: wyd1014
  mesh belt furnace wyd1014 0 227 07-25-2022, 08:10 AM
Last Post: wyd1014
  Production process requirements for industrial furnaces wyd1014 0 299 07-21-2022, 09:10 AM
Last Post: wyd1014
  Osinbajo: Special-Agro Industrial Processing Zones Set To Commence In 7 States Edoman 0 707 04-17-2021, 07:31 PM
Last Post: Edoman
  ANALYSIS: Nigeria and The Kiss Of Debt (2) Edoman 0 797 03-03-2020, 04:30 PM
Last Post: Edoman



Users browsing this thread: 1 Guest(s)

{myadvertisements[zone_2]}

About contripeople

Contripeople forum description.

              Quick Links

              User Links

              Advertise